SAFETY DIRECTIONS:
WARNING. Causes skin irritation and serious eye irritation. Wear protective gloves/clothing/eye protection. Wash hands thoroughly after handling. DO NOT SWALLOW.
DIRECTIONS FOR USE:
Use undiluted. Do not mix with detergents or other chemicals. Hard surface disinfectant only. Not to be used on skin. Not to be used on medical or therapeutic devices.
For General Cleaning & Disinfecting: Apply SABCO Ultra Shield to surface, then wipe with a clean cloth or paper towel and leave to dry. Provides up to 30 days or 200 touch antimicrobial protection against gram negative E. Coli and gram positive “S. aureus”, and 7 days protection against Covid-19.
For Cleaning and Disinfecting of direct food contact surfaces: Once surface has been cleaned and disinfected with SABCO Ultra Shield and where no residual anti-microbial quat/polymerfilm is required, rinse surface with clean potable water and allow to dry before re-use. The ingredients within the quat/polymer anti-bacterial film are safe for indirect food contact.
For Mould and Mildew Remediation: Spray SABCO Ultra Shield on surface to be treated until area is evenly covered. Leave for 10 minutes, allowing SABCO Ultra Shield to penetrate mould, then wipe vigorously with an absorbent or slightly abrasive cloth material to remove visible mould and dirt. Wipe off any remaining visible mould. If rinsing is required, for best residual activity repeat application of SABCO Ultra Shield and allow to dry. Can be re-applied to clean & treated areas.
For soft furnishing, fabric and carpet stains application: It is recommended to spot test first on a small area to ensure that no discolouration occurs. SpraySABCO Ultra Shield evenly over area until slightly damp, leave for up to 30 minutes then wipe with a clean cloth. Repeat if necessary.
This invisible anti-microbial quat/polymer film is easily removed by re-application on hard surfaces or by rinsing the cleaned surface with water after application. There is no build-up from repeated applications. SABCO Ultra Shield is compatible with most surfaces except copper.
FIRST AID:
If swallowed, do NOT induce vomiting. If in eyes, hold eyelids apart and flush the eye continuously with running water. Continue flushing until advised to stop by Poisons Information Centre or a doctor, or for at least 15 minutes. If skin or hair contact occurs, remove contaminated clothing and flush skin and hair with running water. For advice, contact a Poisons Information Centre (in Australia phone 131126, in New Zealand 0800 764 766) or a doctor (at once).